Issue link: https://cp.revolio.com/i/989729
21 ista views • May 2018 • www.ista.org Tilt Test Results & Observations The results for the unit loads tested per the procedure identified in Section 2.2.2 are reported in Tables 3-5. The tilt angles identified in Table 3 are simply identifiers for subsequent testing. The third replicates for 15 tilt pre-test for AABBAA stack pattern were not undertaken due to failures observed in the subsequent mid-tilt tests towards ensuring the safety of the equipment and operators. Consequently, all tests for 20, 22.5 and 25 were omitted. The third replicates for 10 tilt test for AAAABB stack pattern were not undertaken due to failures observed in the subsequent mid-tilt tests towards ensuring the safety of the equipment and operators. Consequently, all tests for 15, 20, 22.5 and 25 were also omitted. Tilt Angle Layer Face 4 Face 2 Replicate 1 Replicate 2 Replicate 3 Replicate 1 Replicate 2 Replicate 3 Stacking Pattern AABBAA 5ͼ Top 5.72 6.99 5.72 3.18 2.54 6.35 Middle 7.62 5.08 5.72 3.81 3.18 5.72 Bottom 4.45 3.18 6.99 3.18 5.08 3.81 10ͼ Top 3.81 5.72 3.18 6.35 5.08 3.18 Middle 3.18 7.62 1.91 5.72 2.54 6.35 Bottom 3.81 3.18 2.54 3.81 2.54 5.72 15ͼ Top 3.81 4.45 - 3.18 0.64 - Middle 3.81 5.72 - 3.18 3.18 - Bottom 3.18 5.72 - 2.54 4.45 - Stacking Pattern AAAABB 5ͼ Top 1.27 1.27 5.08 6.35 3.81 1.91 Middle 4.45 3.81 5.08 4.45 5.08 2.54 Bottom 1.91 4.45 5.08 4.45 4.45 5.08 10ͼ Top 4.45 3.18 - 3.81 3.18 - Middle 4.45 3.81 - 3.81 4.45 - Bottom 4.45 3.18 - 2.54 5.08 - Table 3: Pre-Test Offset Measurements (cm) Tilt Angle Replicate 1 Replicate 2 Replicate 3 1 minute 10 minutes 1 minute 10 minutes 1 minute 10 minutes Stacking Pattern AABBAA 5ͼ 6.99 6.35 7.62 7.62 7.62 7.62 10ͼ 12.07 13.97 13.34 15.24 12.7 13.97 15ͼ Failed Failed Failed Failed Did not attempt due to prior failures Stacking Pattern AAAABB 5ͼ 2.54 2.54 5.72 8.89 8.26 8.26 10ͼ Failed Failed Failed Failed Did not attempt due to prior failures Table 4: Mid-Tilt Test Offset Measurements (cm) > MORE ON PAGE 22